Use this switch wherever on/off power control is desired. It may be used on either 12 or 115 volt lines with zip type cords between 16 and 20 gauge. No soldering, only a screwdriver and wire cutter are required for assembly. To connect, disassemble the switch, cut a segment from one conductor, install wires in the switch, and reassemble. Sharp teeth inside the switch make the necessary electrical contacts. This is the same switch as used on the CK1008 series of lead-in wires. Measures 1-1/4" by 5/8".

Our small SPDT slide switch is well suited for round wire systems involving soldered connections in imbedded locations. It may be located in a wall cutout for either room or complete dollhouse power control. Measures 5/8" long by 3/16" wide by 3/8" deep.

Wiring Kits

Transformers

Outlet, Plug, &
Switch Products

Tools

Books & Videos

Home

Catalogs

Books

Order

Paint

Miniatures from England

Dijon, Ltd.

Warwick Miniatures

New

Contact

Brands

Map

Closeouts

**Prices Subject To Change Without Notice.**

All returns must be made within
30 days for a store credit.