Cir-Kit Concepts - Tools Page 2 from Fingertip Fantasies Dollhouse Miniatures

Dollhouse TOOLS for Electrical work Page 2
from FINGERTIP FANTASIES Dollhouse Miniatures


	Awl (CK1044) Awl Replacement Pins (4 pack)(CK1044-1)	$9.96 $1.98
This tool has been designed specifically for placement of the CK1023 series of eyelets. The awl is first used to make starter holes where eyelets are desired. The eyelet is then slipped over the awl insertion pin and pushed into place. It provides an extremely simple method of making electrical connections in hard to reach dollhouse locations. Made with a rugged wood handle formed to comfortably fit the hand. A hollow compartment in the metal shank provides convenient storage for the four insertion pins. Both shank and punch are nickel plated. Overall length is approximately 4-5/8". Instructions in package.

	5" Locking Forceps, Curved Tip (CK1046) 5" Locking Forceps, Straight Tip (CK1046-1)	$7.96 $7.96
	These forceps provide a significant advancement in the brass brad insertion process. Their locking handles and fine serrated teeth allow easy gripping and holding of 1/8" brass brads in even the most awkward locations. Made of surgical stainless steel these tools are ideal for home or shop workbench. Overall length 5".

	Jeweler's Screwdriver Set (CK1050)	$3.96
	This set of five nickel-plated jeweler's screwdrivers is a must for installing or removing any small gauge screw. They have been designed with heads that swivel and blades that are permanently affixed to a knurled handle. Shaft blades range from widths of .049" to .079" with overall lengths between 3" and 3-3/8".

	Bulb Extractor (CK1051)	$3.96
	At last a tool to eliminate the maddening task of screw bulb removal. Some chandeliers are designed in such a manner as to make bulb removal nearly impossible. The CK1051 Bulb Extractor simplifies this effort and makes light work out of a previously difficult task. Simply slide down over bulb, twist it and remove the bulb. Flexible teeth adjust to grip the wide variances that exist in bulb design and manufacture. The hollow rubber tip on the opposite end may be used for gripping bulbs when only the tips are exposed. It may also be removed for tight access locations. Nickel plated, brass construction assures a lifetime of satisfactory operation. Use with all screw-base type flame-tip bulbs.


	Wire Stripper (CK1052) $1.96 Use this handy wire stripper for stripping CK203-1 speaker type 24 gauge wire. Simply clip over wire, compress teeth and pull. Illustrated instructions included with each package.

	Low-Voltage Soldering Iron (CK1053) $14.96 Our low-voltage soldering iron works with any 12-volt Cir-Kit Concepts' transformer or 12-volt car battery. Heats to solder melting temperature in 3 to 4 minutes. Safest soldering iron yet. Use with CK1033-1 solder.

Wiring Kits	Transformers	Outlet, Plug, & Switch Products	Tools
Lamps & Fixtures	Lights Bulbs	Tape & Lead Wires	Books & Videos
Wiring Products	Hardware Products	Lighting Accessories	Fireplace Grates